双组份打胶机由 A、 B型胶泵、气动系统、升降机构、机架等组成。各点如下：

The two-component coating machine is composed of A, B type glue pump, pneumatic system, lifting mechanism, frame and so on. The points are as follows:
胶泵：

Rubber pump:
A、 B组各设一台胶泵，在各自的气马达带动下，分别作往复运动，将胶吸出并压出。B、 A、 B分别固定在压胶盘上，然后与机架连接形成各自的系统。

A, B group each set a rubber pump, driven by their own gas motor, respectively, the reciprocating movement, the rubber out and pressure. B, a, B are respectively fixed on the pressure plate, and then connected with the rack to form their own system.
B组份的比例由比例杠杆调节：向内调节， B排出胶减少，向外调节， B排胶增大。采用比例杠杆控制 B胶出胶量，从而控制 A、 B胶的比例。

The proportion of component B is regulated by proportional lever: Adjusting inwards, reducing the amount of glue discharged from B, adjusting outwards, increasing the amount of glue discharged from B. The proportion of A and B glue is controlled by proportion lever.
出胶：由气源处理器控制，逆时针调整，出胶量增加，顺时针调整出胶量减少。(此处指出胶总量)

Tapping: controlled by air source processor, counter-clockwise adjustment, the amount of tapping increased, clockwise adjustment of the amount of tapping decreased. (the amount of glue indicated here)

该胶泵通过比例杠杆调节 A、 B的胶量比例，具有操作灵活、性能稳定、调节范围大等特点。

The rubber pump adjusts the proportion of a and B by proportional lever. It has the characteristics of flexible operation, stable performance and large adjustment range.
升降机构：

Lift mechanism:
双组份打胶机在B组份胶泵分别设置一套气动提升机构，所述提升机构分别由两个并联的气缸组成，并通过横梁固定连接各自的泵体。两缸间的力通过压盘作用于胶面，压力大小由调压阀调节，一般为0.3 MPa左右；第二，在需要更换胶桶时，可通过气缸将压盘提起。退出胶桶，以替换新胶桶。

The Component B rubber pump is respectively provided with a set of pneumatic lifting mechanisms which are respectively composed of two parallel air cylinders and fixedly connected with respective pump bodies through crossbeams. The force between the two cylinders acts on the rubber surface through the pressure plate, the pressure is adjusted by the pressure regulating valve, generally about 0.3 MPA. Exit the Pail to replace the new pail.