玻璃在现在的建筑中，应用越来越广泛！玻璃施工就离不开方便快捷的打胶机！下面全自动打胶机厂家就给大家普及一下，调试打胶机时有哪些都需要注意的事项！
Glass is more and more widely used in modern architecture. Glass construction is inseparable from a convenient and fast glue beater! The following full-automatic glue machine manufacturers will popularize to you, debugging glue machine when there are what need to pay attention to!
1、在当天机器操作完毕后要把胶管内的胶冲出，防止硬化；如果长时间不实用要注意用煤油清洗胶管和胶枪。
1. After the machine is finished, the glue in the rubber tube should be washed out to prevent hardening. If it is not practical for a long time, we should pay attention to cleaning the rubber tube and gun with kerosene.
2、双组份打胶机使用的硅酮胶或聚硫胶要注意杂质不能过高，低质量的胶容易堵塞胶管的过滤系统，造成出胶不畅或不均匀。
2. Silicone glue or polysulfide glue used in two-component glue beater should pay attention to the impurities should not be too high, low-quality glue is easy to block the filter system of rubber hose, resulting in poor or uneven glue production.

3、在更换胶的品种时要特别注意把双组份打胶机内残留的胶冲净，应该清洗干净，因为不同品种甚至的胶容易反应堵塞机器。
3. When replacing rubber varieties, special attention should be paid to rinsing the residual glue in the two-component glue beater, and it should be cleaned, because different kinds or even brands of glue are easy to react to clogging the machine.
4、液压站系统的压力，不能调的太高，要根据室内环境温度等实际情况，调至满足胶嘴正常出胶均匀打胶即可。打开液压站时一定要打开胶枪，否则B组份管路压力将升得很高，造成安全事故。
4. The pressure of hydraulic station system can not be adjusted too high. According to the actual situation of indoor environment temperature, it can be adjusted to meet the normal tapping of rubber nozzles. When opening the hydraulic station, the rubber gun must be opened, otherwise the pressure of component B pipeline will rise very high, resulting in safety accidents.
今天就暂且和大家聊到这里，希望这篇由全自动打胶机的小编整理的知识可以帮助到您，如果您对此还有疑问，详情请咨询我们的官方。http://linshi.jncsjx.com
I'm going to talk to you for a moment today. I hope this article can help you. If you have any questions about it, please consult our official for details. Http://linshi.jncsjx.com